Functions Of The Transmitter; A) General Basic Functions; B) Special Basic Functions; C) Additional Functions For Helicopter Models - Reely Hughes Bedienungsanleitung



8. Functions of the Transmitter

a) General basic Functions

• LED display
• 5 model memories
• 6 channels (4 channels by control cross, 2 channels by switches for flight model programmes)
• Digital trimming for channels 1 - 4
• Programming possibility for modes 1 - 4 (helicopters: only modes 1 and 2)
• Travel setting for all channels from 0 - 120%
• Servo reverse for all channels
• Servo central setting for all channels
• Dual rate converter for ailerons (rolling) elevator (pitching), rudders (yawing)
• Alarm at an operating voltage of less than 8.6 V at the transmitter
• Charging socket

b) Special basic functions

• 3 different plane model programmes
- AP: Simple programme for flight models
- VP: Programme for flight models with V-tail
- DP: Programme for delta wing models
• 3 different helicopter model programmes
- HP1: Pitch control with 1 servo
- HP1: Pitch control with 2 servos
- HP3: Pitch control with 3 servos (CCPM 120)

c) Additional functions for helicopter models

• 5-point gas curve for normal flight and aerobatics
• 5-point pitch curve for normal flight, aerobatics and throttle hold
• Throttle hold mode
• Changing the gyro sensitivity in-flight

d) Additional functions for plane models

• V-tail mixer
• Delta wing mixer
• Throttle hold mode
• 2 separate switching channels for special functions (e.g. retractable landing gear)
121