The centrifugal weight rod (1) at the upper rotor must be
aligned precisely straight and its ends must be easy to move.
The linkage levers of the upper rotor (2) must not be difficult
to move or catch in any position.
c) Inserting the Flight Batteries
The charged flight battery (1) is slid into the battery holder
(2) below the skid brackets. The two contacts (3) must point
downwards.
d) Switching the Helicopter on
Move the control stick with latch function (also see figure 1,
item 4) to the bottom position and switch on the transmitter.
Switch on the helicopter immediately after this. Slide the
function switch (1) from the "Off" position to the "On" posi-
tion.
36
Figure 11
Figure 12
Figure 13