Herunterladen Inhalt Inhalt Diese Seite drucken

Eaton xChargeIn M Serie Konfigurationshandbuch Seite 81

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

xChargeIn M Series
5.2.4
RFID authorization with OCPP backend connection
If the charging station or a charging network is controlled by an OCPP back-
end, please note the following:
Information
For information on the functionality and the required settings of the OCPP
backend, refer to the specific manual of the system used.
5.2.5
Start charging process with RFID authorization
To start a charging process with RFID authorization, proceed as follows:
1) Plug the vehicle into the charging station.
2) Hold the RFID card, which was previously taught in, in front of the RFID
3) The rising tone sequence and the green flashing LED bar indicate that
4) If necessary, the charging process can be stopped prematurely by hold-
Information
Enable input X1
For special device variants, the enabling of a charging session can also be
controlled via the enable input X1 (for connecting external components
such as a timer, photovoltaic system or home control). If this function has
been activated in the DIP switch settings, enabling a charging session will
additionally require a correct signal on the enable input X1. Further informa-
tion can be found in the "Installation Manual".
Configuration manual V1.04
© EATON
Teach in RFID cards:
All RFID cards must be "centrally taught in" at the OCPP backend.
"Authorization" in the web interface to "ON":
Each authorization request is relayed to the OCPP backend.
"Authorization" in the web interface to "OFF":
A charging process can only be started without holding up an RFID card
if the predefined token set in the configuration is recognized and ac-
cepted by the OCPP backend.
reader.
the RFID card has been accepted.
The charging process can now be started by the vehicle.
ing the same RFID card in front of the RFID reader again.
Functions
81

Werbung

Kapitel

Inhaltsverzeichnis

Fehlerbehebung

loading

Inhaltsverzeichnis