Eaton xChargeIn M Serie Konfigurationshandbuch Seite 79

xChargeIn M Series
OfflineNoAuthorization
OfflineNoCharging
5.2.2 Displays and signals
During RFID authorization, the charging station can display different light
patterns on the LED bar and emit acoustic signals.
LED bar
Flashing green
(every 3 seconds)
Flashing blue
(every 3 seconds)
Illuminated orange
(once)
Acoustic signals
Single tone
Rising tone sequence
Falling tone sequence
The charging station can also display a text concerning the RFID authoriza-
tion, e.g. "accepted card". This text can be customized via the web interface.
5.2.3 RFID authorization without OCPP backend connection
The following options are available for managing RFID cards:
●
●
Managing RFID cards at the RFID reader
Both the master RFID card and all slave RFID cards can be taught in directly
at the RFID reader of the charging station. To teach in an RFID card, no
charging session may be active and no vehicle may be plugged into the
charging station.
Teaching in a master RFID card
To access the "Service button", the housing cover and the connection panel
cover must be removed.
Configuration manual V1.04
© EATON
Mode
All RFID cards are temporarily accepted. As soon as the con-
nection to the OCPP backend exists again, the RFID card is
checked and, if an invalid RFID card is being used, the charging
process is canceled.
Charging is not possible for a connection failure.
Display
Authorization is done correctly.
The charging station is waiting for authorization to enable a
charging process. Authorization necessary, either with RFID
card or by an external input.
The RFID card is invalid.
Signal
RFID card has been read.
RFID card has been accepted.
RFID card has been rejected (no authorization).
At the RFID reader of the charging station
In the web interface
Description
Description
Description
Functions
79