Managing Rfid Cards In The Web Interface - Eaton xChargeIn M Serie Konfigurationshandbuch

Functions
1) Press and hold the "Service button" in the connection panel until the
2) The charging station will be available again after 30 seconds.
3) After the waiting time, the first three segments of the led bar are illumi-
Teaching in a slave RFID card
1) Hold the master RFID card in front of the RFID reader and wait for the
2) Then hold the slave RFID card to be programmed in front of the RFID
3) Confirm the teach-in process by holding up the master RFID card again

Managing RFID cards in the web interface

RFID cards can be managed via the configuration in the web interface. The
following functions are available:
●
●
Information
It is recommended to use a text editor for editing the *.csv file. Otherwise
the date can be interpreted incorrectly upon import.
The following entries can be made during teaching-in and editing of an RFID
card:
RFID Card –
Serial No. (UID)
Expiry Date
Master RFID Card
Status
Charging Station –
Serial No.
80
second signal tone is sounded (approx. 10s).
The charging station will then automatically perform a restart, deleting all
previously taught-in RFID cards, if necessary.
nated. A master RFID card can be taught in for 30 seconds by holding it
in front of the RFID reader.
A successful teach-in process is confirmed by a rising tone sequence.
rising tone sequence.
reader within 10 seconds and wait for the signal tone.
within 5 seconds.
A successful teach-in process is confirmed by a rising tone sequence.
Teaching-in, editing or deleting an RFID card
Exporting or importing a list of stored RFID cards as
Entry
Serial number (UID) of the RFID card. This can be read out with
a suitable mobile phone app, for example.
Date up to which the RFID card is to be valid.
Set the RFID card as master RFID card. Only one card can be
defined as master RFID card.
Authorization of the RFID card. Here it is also possible to block
an RFID card and thus prevent charging with the relevant RFID
card.
Serial number of the charging station where the RFID card may
be authorized. All or only certain charging stations in the charg-
ing network can be enabled for the RFID card.
xChargeIn M Series
file
*.csv
Description
Configuration manual V1.04
© EATON