Eaton xChargeIn M Serie Konfigurationshandbuch Seite 74

Web interface
Device
The basic settings for the charging station are configured here:
Managing the authorization function (see
chronize time of the charging station with the time of the browser (the charg-
ing station restarts after a time synchronization); activating and deactivating
the USB stick functions.
Phase Assignment
The connection type (1-phase or 3-phase) of the charging station is selected
here. With 1-phase connection, the core of the supply line used can also be
selected. For a charging network, the connection type of the slave charging
stations is also selected here.
Charging Parameters
The nominal supply voltage of the charging station is selected here and the
current limits for the charging network can be set.
With 1- or 2-phase charging vehicles, asymmetrical loading of the 3 phases
may occur. For such vehicles, the maximum charging current can be set in
this area. The charging station then detects whether the vehicle is a 1-, 2- or
3-phase charging vehicle and, if necessary, reduces the charging current to
the set value. If "0" is entered, this function is deactivated.
You can also set whether charging should continue after a power failure.
This setting is disabled by default.
Network Connection
The network communication can be selected and configured here.
Certificates
Certificates in
The connection to the web interface, to the OCPP backend and to the charg-
ing station can be encrypted. The following certificates are available:
Https WebUI
OCPP Server
OCPP Client
WLAN Access Point
The WLAN access point can be configured here and enabled or disabled as
required.
74
format can be imported for an encrypted connection.
*.pfx
Certificate
Web interface
OCPP backend
Charging station
5.2.1 Authorization
Encrypted
connection to ...
xChargeIn M Series
modes); syn-
Required key
Private key
Private key
Public key
Configuration manual V1.04
© EATON