Checking The Audio Input Signal Type - Yamaha DVR-S150 Bedienungsanleitung

Checking the Audio Input Signal
Type
You can check the information on the audio input signal
currently played back on the CinemaStation.
STANDBY/ON
AUDIO ANGLE
SURROUND SELECT MATRIX 6.1
REPEAT
NIGHT
SW CENTER
SET MENU
TV INPUT
TV CH
A B C D E
PRESET
PTY SEEK
FREQ/RDS MODE
ON SCREEN
START
YPAO
CH
ENTER
STATUS
TEST
ON/OFF
VOLUME
TV VOL
MUTE
AMP
DVD/CD
VCR
TUNER
MOVIE MUSIC SPORTS
CINEMA
1
Play the source of which you want to check
the audio input signal type.
2
Press AMP.
3
Press STEREO
Stereo playback starts.
POWER
TV
SUBTITLE
STEREO
STEREO
A-B
SURR
SHIFT
SLEEP
PRESET
START
MENU
CH
RETURN
AMP
VIDEO
GAME
Configuring the Audio Input Signal Setting
4
Press .
Audio input signal information appears on the
CinemaStation display.
Each time you press the button, information changes
depending on the input source.
• Audio input signal type
Shows the format of the audio signal. When the
digital audio input cannot be recognized, the mode
is automatically set to analog audio input.
• Audio channels (only for Dolby Digital and
DTS)
Shows the number of audio channels the input
signal contains. For example, "in: 3/2/LFE"
indicates 3 front channels, 2 surround channels,
and LFE. "1+1" indicates main/sub audio in
bilingual broadcasts or other 2-channel audio, and
MLT indicates audio with 3 channels or more.
• Frequency (fs) (only for digital signals)
Shows the frequency sampling of the input signal.
If the sampling frequency cannot be measured,
"unknown" appears.
• Bit rate (rate) (only for Dolby Digital and
DTS)
Shows the amount of data the input signal contains
per second. If the bit rate cannot be measured,
"unknown" appears.
• Flag (flg) (only for Dolby Digital and DTS)
Shows the recognition signal (flag) the input signal
contains. If the flag cannot be recognized, "None"
appears.
About digital signals that exceed 48 kHz
CinemaStation's digital input jack supports a sampling
frequency up to 96 kHz. Before connecting an AV
equipment to the digital input jack, read the manual for it
to check the sampling frequency. Also, be sure to the
following notes when inputting a digital signal that
exceeds 48 kHz.
• DSP Programs are not selectable. You can only listen
to normal 2ch stereo from the front speakers.
• During playback, you cannot adjust the volume level of
center and surround L/R speakers.
• Depending on the "Setting speaker sizes (Speaker Set)"
settings in the Set Menu (page 77), the Subwoofer may
output sound.
71