Troubleshooting; General - Yamaha DVR-S150 Bedienungsanleitung

TROUBLESHOOTING

If there is any problem with your CinemaStation system, check the following items. If you cannot solve your problem
with the following remedies or if your problem is not listed below, turn off and unplug the CinemaStation, then consult
the nearest authorized YAMAHA dealer or service center.

General

Problem
Power turns on but
immediately shuts off
The speakers make no
sound
The TV shows no picture
Sound suddenly turns off
Sound is too low on one
side
Speakers other than the
front ones make no sound
80
Troubleshooting
Cause
The system cable may be connected
improperly.
The power cable may be connected
improperly.
The speaker cable may be shorted.
The CinemaStation may receive a
strong electrical shock such as from a
lightening bolt or excessive static
electricity.
The volume may be set to minimum
level.
The Mute function may be enabled.
The input source or input setting may
be incorrect.
The cables may be connected
improperly.
The disc loaded into the
CinemaStation may be not
compatible.
You are playing a DTS source and
"PCM Only" is selected for "Digital
output" in the On-Screen Menu.
The cables may be connected
improperly.
The Sleep Timer (page 28) might be
set.
The cables may be connected
improperly.
You may be listening to stereo
sounds without the sound field effect.
You may be listening to an audio
source (Dolby Digital or DTS) that
does not contain any special effect
signal.
Solution
Make sure the system cable is
connected properly. (page 10)
Make sure the power cable is plugged
into the outlet firmly. (page 17)
Make sure all speaker cables are
connected properly. (page 10)
Set the CinemaStation to the Standby
mode, then disconnect the power cable.
Wait for about 30 seconds, then connect
the power cable and turn on the
CinemaStation.
Adjust the volume level. (page 20)
Cancel the Mute function. (page 20)
Select the correct input source or input
setting. (pages 19 and 70)
Make sure all cables are connected
properly. (page 9)
Make sure you use a disc supported by
the CinemaStation. (page 32)
Select "All" for "Digital output" in the
On-Screen Menu. (page 30)
Make sure all cables are connected
properly. (page 12)
Turn on the CinemaStation and play the
source again.
Make sure all cables are connected
properly. (page 9)
Press STEREO to enable the sound
field effect. (page 63)
Select another DSP program. (page 26)