Radio Reception - Yamaha DVR-S150 Bedienungsanleitung

Radio reception

FM/AM
Problem
The Preset Tuning function
(page 49) does not work
FM
Problem
Too much noise is
generated during stereo
broadcast
Even with an outdoor
antenna, radio wave
reception is weak (audio is
distorted)
The Auto Tuning function
(page 48) does not work
AM
Problem
The Auto Tuning function
(page 48) does not work
Too much noise is
generated
Cause
The preset (memory) may have been
erased.
Cause
The FM antenna may be connected
improperly.
The radio station you selected may
be far away from your area or radio
wave reception is weak in your area.
Multipath reflection or other radio
interferences may occur.
The radio station you selected may
be far away from your area or radio
wave reception is weak in your area.
Cause
The AM loop antenna may be
connected improperly.
The radio station you selected may
be far away from your area or radio
wave reception is weak in your area.
The noises may be generated from
atmospheric electricity, lightening,
fluorescent lights, motors, or
thermostat electric devices.
If too much noise is generated
especially in the evening, the
CinemaStation may be placed close
to a TV.
Troubleshooting
Solution
Preset radio stations again. (page 51)
Solution
Make sure the FM antenna is connected
properly. (page 13)
Try Manual Tuning to increase the
signal quality (page 48) or use a
multi-channel outdoor antenna.
Change the antenna's height, direction,
or placement.
Try Manual Tuning to increase the
signal quality (page 48) or use a multi-
channel outdoor antenna.
Solution
Make sure the AM loop antenna is
connected properly. (page 13)
Try Manual Tuning to increase the
signal quality (page 48).
Connect an outdoor antenna and
establish better grounding to decrease
noises. However, it is difficult to
eliminate these types of noises.
Place the CinemaStation further away
from a TV.
85