Finding A Wire Break - Viking MI 422 Gebrauchsanleitung

Insert the puller (K) and turn anti-clockwise
to the stop.
Support the machine with one hand.
Remove the carrier plate (1) by pulling on
the puller (2).
132
Installing the carrier plate:
Thoroughly clean the blade shaft (1) and
the mounting on the carrier plate (2). Push
the carrier plate as far as possible onto the
blade shaft.
● Install the mowing blade. (

15.7 Finding a wire break

In the event of a wire break, the red
LED on the docking station flashes
rapidly. ( 12.1) A corresponding
message appears in the display of
the robotic mower.
If a wire break cannot be found as
described, contact your VIKING
specialist dealer.
Remove the docking station cover and
disconnect the right perimeter wire
end (1).
The following instructions describe how to
search for a wire break in a clockwise
direction, i.e. the perimeter wire is followed
in a clockwise direction starting at the
docking station. The search can also be
15.4)
performed in an anti-clockwise direction if
necessary, however the left perimeter wire
end must then be disconnected.
● Remove the robotic mower from the
docking station.
● In the "Service" menu, select the "Find
wire break" entry and confirm with OK.
( 10.17)
0478 131 9923 B - EN