Assembling The Grass Catcher Box; Controls; Mono Handlebar (Me 443 C); Dual Handlebar (Me 443) - Viking ME 443 Gebrauchsanleitung

● Fasten the electric cable (3) to the
upper handlebar with the cable clip (H).
Ensure a distance of 25 - 27 cm
between cable clip and switch on upper
handlebar.
● Insert the electric cable (3) into the
holder (4) of the handlebar console as
shown.
7.4 Assembling the grass
catcher box
● Fit the upper part of the grass
catcher box (B) onto the lower part of
the grass catcher box (C). Ensure
correct location in the guides.
● Push pin (D) through the bores
provided from inside.
● Allow the upper part of the grass
catcher box (B) to engage in the lower
part of the grass catcher box using
slight pressure.
● Attach the grass catcher box (
0478 121 9920 C - EN

8. Controls

8.1 Mono handlebar (ME 443 C)

The lawn mower ME 443 C is
equipped with an adjustable mono
handlebar.
Danger of electric shock!
The electric cable must always be
5
attached to the quick-release clamp
body and the handlebar console.
Danger of pinching!
Before actuating the detent
lever (1), hold the upper
handlebar (2) with one hand at its
highest point and lift (relieve load)
slightly.
After actuation of the detent lever,
the upper handlebar can fall to the
lowest position under its own
weight.
8.3).
Never place your finger between
the handlebar and the handlebar
console (under the detent lever).
1 Folding down the handlebar:
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Press the detent lever (1) downwards
and hold.
● Fold the handlebar (2) down forwards,
ensuring that the electric cable is not
damaged.
Working position (to push machine):
● Fold the handlebar (2) up rearwards
and ensure that the handlebar is fully
engaged.
2 Height adjustment:
The height of the mono handlebar can be
6
adjusted to 2 levels:
● Press the detent lever (1) downwards
and hold.
● Move the handlebar (2) into the
required position.
● Release the detent lever (1) and ensure
that the handlebar is again fully
engaged.

8.2 Dual handlebar (ME 443)

Danger of pinching!
The upper handlebar can be folded
down by releasing the quick release
caps. For this reason, always hold
the upper handlebar (2) with one
hand at its highest point when you
open the quick-release caps.
Transport position (for cleaning, for
space-saving transport and for storage of
the machine):
● Open the quick-clamping devices (1) –
fold downwards – and fold the upper
handlebar (2) forwards, ensuring that
the electric cable is not damaged.
Working position (to push machine):
● Fold up the upper handlebar (2)
rearwards and hold with one hand.
● Close the quick-clamping devices (1) –
fold upwards.
7
41