Accurate Mowing Along Edges; Sloping Terrain In The Mowing Area - Viking MI 422 Gebrauchsanleitung

Installing the start and end of the
corridor:
The perimeter wire (1) must be routed in a
funnel shape as shown at the start and end
of the corridor (clearances A and B).
This prevents the robotic mower from
accidentally driving into the corridor during
mowing.
A = 22 cm
B = 6 cm
Installing corridor:
Wire clearance in corridors: 22 cm
0478 131 9923 B - EN
This results in the following space
requirements:
– between high obstacles (over 2 cm in
height – e.g. walls):
88 cm,
– between paths / obstacles that can be
travelled on (lower than 2 cm in height –
e.g. paths):
22 cm.
In corridors, the perimeter wire (1) must be
routed parallel and attached to the ground
with a sufficient number of fixing pins (2).
At the start and end of the corridor, funnel-
shaped entrance and exit areas must be
installed.

11.11 Accurate mowing along edges

At a track offset of 6 cm, a strip with
a width of up to 20 cm is left
unmown along high obstacles. If
necessary, edging stones can be
laid around high obstacles.
Minimum width of edging stones:
Route perimeter wire (1) at a clearance of
22 cm to the obstacle. To ensure that the
lawn edge is mown completely, the edging
stones must have a width of at least 20 cm
(clearance B). If wider edging stones are
laid, the lawn edge is cut even more
precisely.
Route the perimeter wire with a
greater clearance to the edging
stones around exterior and interior
corners. ( 9.1)
Use wider edging stones if
necessary.
11.12 Sloping terrain in the mowing
area
In order for the robotic mower to
automatically mow a slope in the mowing
area (incline up to 15°) trouble free, the
perimeter wire must be installed in the
slope with a minimum clearance to the
edge of the incline.
123