A
Prepare the
striking plate
pocket
Fasten the striking
plate
EN
74
Mounting the striking plate
Important!
Property damage due to sharp limiter edge: The limiter edge of a striking plate
must not be sharp, as this could result in damage due to abrasion. If a striking
plate, such as a flanged striking plate, needs to be adapted on site, the limiter
edge must be rounded smooth with a radius of at least 0.5 mm.
1
Cut out the striking plate pocket.
2
Finish the holes for the fixing screws.
3
Clean the striking plate pocket and all holes by blowing them out or
vacuuming.
4
Fasten the striking plate.
The striking plate is mounted.
Mounting