Prepare the lock
pocket
Clean the lock
pocket
I
Adjust the closing
direction and
panic side
Fasten the lock
EN
72
Mounting the OneSystem SBP lock
Cutting dimensions for the lock pocket
The lock pocket must be cut out such that the lock case has some play, but does
not sit too loosely. The cutting depth must match the backset of the lock.
Prepare the lock pocket
1
Cut out the lock pocket according to (page 99ff).
2
Finish the holes for the fixing screws (page 99ff).
3
Finish the holes for the lock fittings.
4
Clean the lock pocket and all holes by blowing them out or vacuuming.
The lock pocket is now ready for the lock assembly.
Preparing and mounting the lock
Note!
Observe additional settings: For locks with a monitoring function, additional
settings must be carried out.
1
Adjust the closing direction of the latch bolt and the control latch
("Prepare the lock pocket", page 72).
2
Adjust the panic side ("Changing the panic side", page 78).
The lock is now ready for installation.
3
Only for locks with monitoring: Insert the cable.
4
Insert the lock into the lock pocket and fasten it to the face plate.
Once the striking plate is mounted, the lock is ready for use.
Mounting