Assa Abloy OneSystem N7 Serie Montageanleitung Seite 67

Tab. 4 :
Classification key
in accordance with
EN 14846
Safety instructions
EN 14846
The properties of locks are described by the nine-digit classification key according
to EN 12209.
The classification key for the
N7XXX OneSystem SBP lock:
Tab. 4 explains the classification key.
Class Meaning
3 For use by the public, where there is little incentive to take care and
there is a high likelihood of misuse, such as in doors in public buildings.
S 200,000 test cycles with a latch load of 50 N
6 Door mass 300 kg, max. 25 N closing force,
see „EN 1125 – Panic function B, C and E" and „EN 179 – Panic function
B, C and E", page 64ff, as use in accordance with these standards
reduces the maximum door mass
C Suitable for use on fire doors/smoke protection doors with a classifica-
tion time T30 (30 minutes resistance to fire).
– No safety requirements
see „EN 1125 – Panic function B, C and E" and „EN 179 – Panic function
B, C and E", page 64ff, as use in accordance with these standards
demands higher requirements
L High corrosion resistance, at –25 °C to +70 °C and with humidity
level 2
6 Very high protective effect and no drilling resistance.
1 Signal if the dead bolt is fully extended and locked. (The signal can be
queried on an IO module.)
3 Characteristics:
· Protection against power failure, the effects of cables being cut
through and the impacts of wire manipulations
· Resistance against electro-magnetic manipulations
· Resistance at level 4 (EN 61000-4-2) against electrostatic discharge
and manipulations
· Discharge on contact:
· Discharge via air:
3 S 6 C
± 8 000 V
± 15 000 V
– L 6 1 3
EN 67