Remote Commander Operation; Remote Commander (Rm-R500) (Supplied With Pms-500P Only) - Sony PMS-500P Bedienungsanleitung

Remote Commander Operation

You can operate the menus from the Remote
Commander (RM-R500) (supplied with PMS-500P).

Remote Commander (RM-R500) (Supplied With PMS-500P Only)

1 DISCONNECT keys
2 DIAL key
3 Number (1 – 0) keys
4 PTZ CONTROL PAN/
TILT (V,v,B,b) keys
5 FOCUS (FAR/NEAR) keys
6 ZOOM (TELE/WIDE) keys
7 MUTING key
8 VOL (volume) (+/–) keys
9 Cursor keys (V,v,B,b)
0 ENTER key
1 DISCONNECT keys
Press these two keys simultaneously to disconnect the
line.
2 DIAL key
Press this key to call the remote site, the DIAL KEY
menu appears. (See page 3-2 (GB).)
While the DIAL LIST appears on the screen, press
Number (1 – 0) keys to select the remote site to be
dialed. After selecting a remote site, press DIAL key to
call the remote site. The system starts to make the
connection.
3 Number (1 – 0) keys
Press these keys to input numbers such as telephone
numbers and subaddresses while you are setting the
menu.
When the DIAL LIST appears on the screen, press
these keys to select the remote site to be dialed.
3-8
(GB) Chapter 3 Operation
The following figure shows the keys on the Remote
Commander.
DISCONNECT DISCONNECT
SUB ADDR
CAMERA
DIAL
1 2 3 4 5
6 7 8 9 0
PTZ CONTROL
MENU
PAN / TILT
TELE FAR OPEN 1
DISPLAY
ZOOM
FOCUS IRIS AUX
NEAR 2
WIDE CLOSE
PICTURE P in P
MUTING — VOL —
CURSOR CONTROL
While in on line mode, you can display the PRE/POST
ALARM REC image or QUAD image by using the
following number keys and the CAMERA key !™.
Key (Camera) number PRE ALARM POST ALARM QUAD
1 (250)
2 (251)
3 (252)
4 (253)
5 (254)
4 PTZ CONTROL PAN/TILT (V, v, B, b) keys
These keys adjust the camera angle.
The B key functions as a BS (back space) key when
adjusting the SETTING menu during off line.
5 FOCUS (FAR/NEAR) keys
These keys control the focus of the camera.
FAR: press to focus the picture further away.
NEAR: press to focus the picture closer.
!¡ SUB ADDR (address) key
!™ CAMERA key
!£ MENU key
!¢ AUX (1/2) keys
!∞ DISPLAY key
!§ IRIS (OPEN/CLOSE) keys
!¶ P in P (picture in picture) key
!• PICTURE key
QUAD QUAD
TIME – TIME 0
TIME 0 TIME 1
TIME + TIME 2
TIME ++ LIVE
QUAD
U-LEFT
U-RIGHT
L-RIGHT
L-LEFT