Electromagnetic Compatibility; Electromagnetic Emissions - Acteon satelec Piezotome 2 Benutzerhandbuch

XIII - ELECTROMAGNETIC COMPATIBILITY
Important:
The power cord, the ultrasonic handpiece cords and the multifunction footswitch cord must be
kept away from each other.
P 2 requires special precautions to be taken with regard to electromagnetic compatibility.
IEZOTOME
It must be installed and prepared for use as described in chapter 4.
Certain types of mobile telecommunication devices such as mobile telephones are likely to interfere
with the P 2.
IEZOTOME
The recommended separation distances in this paragraph must therefore be complied with.
P 2 must not be used near or on top of another device.
IEZOTOME
If this cannot be avoided, its operation under the conditions of use must be checked beforehand.
The use of accessories other than those specified or sold by SATELEC as replacement parts may have
the consequence of increasing the emissions or decreasing the immunity of the P

13. 1 ELECTROMAGNETIC EMISSIONS

P 2 is intended for use in the electromagnetic environment specified in the table below. The
IEZOTOME
user and/or installer must ensure that the P
Emission test
RF emission - CISPR 11
RF emission - CISPR 11
Harmonic current emission
IEC 61000-3-2
Voltage fluctuation and flicker
IEC 61000-3-3
IEZOTOME
Compliance
P
IEZOTOME
Group 1 Therefore, its radiofrequency emissions are very low and are not likely
to cause any interference in nearby equipment.
Class A
P
IEZOTOME
establishments and those directly connected to the public low voltage
Class A
power supply network that supplies buildings used for domestic
purposes.
Complies
2 is used in such an environment.
Electromagnetic environment - guidance
2 uses RF energy for internal operation.
2 is suitable for use in all establishments, including domestic
2.
IEZOTOME
21