Piezotome Function; Newtron Function - Acteon satelec Piezotome 2 Benutzerhandbuch

7. 5 PIEZOTOME FUNCTION

Important:
The P function settings can be
IEZOTOME
customized by the user.
The P function settings can be adjusted
IEZOTOME
when no P
IEZOTOME
the device.
The program giving the highest power is D1.
Program
Very powerful D1
Powerful D2
Medium D3
D4
Low
Select the P
IEZOTOME
(Fig. 3-12) or by pressing the footswitch
button (Fig. 8-5).
On the LCD screen, the P
highlighted.
Select the program to be used by pressing button
, ,
using the footswitch button (Fig. 8-3); the
selected program is highlighted on the LCD
screen.
Adjust the programs and the power level
according to
recommendations.
If necessary, modify the irrigation function (flow
rate value, etc.) (refer to 7.3).
If necessary, modify the program power level (1 to
5) using buttons
12
2 handpiece is connected to
Main functions
Osteotomy, osteoplasty
Soft tissue detachment
function by pressing button
tab must be
IEZOTOME
or (Fig. 4-14) or
the tip data
(Fig. 3-6) and
The power level of the program concerned is shown
as a number and a bar-graph
Modify the footswitch type if necessary by
pressing button
ON/OFF
Important:
In progressive mode, for programs D1 to D3,
the delivered power ranges between power
level 1 of program D3 and the configuration
defined by the user (program and power level).
In progressive mode, the power delivered by
program D4 ranges only between levels 1 and 5,
according to the value defined by the user.
If necessary, select handpiece light function
ON/OFF by pressing button
Confirm the new settings by pressing button
(Fig. 3-8).
The saving of the various settings is confirmed by
an audible signal and a visual signal (button
flashing).
Repeat this sequence if necessary in order to
adjust all the programs.
Caution: The tips designed for P
I
MPLANT
P
IEZOTOME
sheet

7. 6 NEWTRON FUNCTION

Important:
A scaler cord and its N
be connected to the device in order to be able
to configure the various settings.
(Fig. 3-7). The N
customized by the user.
(Fig. 3-10) to toggle between
and progressive
C 2 are not compatible with
ENTER
and I C
MPLANT ENTER
EWTRON
function settings can be
EWTRON
(Fig. 4-13).
.
(Fig. 3-11).
2 and
IEZOTOME
, and vice versa.
handpiece must