Werbung
CHK
CONTROL SYSTEM
ADJ
(11) Move the throttle
tion.
(12) Check that the throttle lever
contact with the throttle stop screw
on the carburetor.
NOTE:
If they are not in contact, perform the
adjustment with full-close throttle.
Refer to "Adjustment with full-close throt-
tle:" on page 3-9.
6. Adjusting the throttle control lever:
•
Throttle control lever
Adjustment steps
(1) Set the shift lever
position.
(2) Move the throttle
tion.
(3) Check that the magnet base stopper
is in contact with the stopper on the
engine body (full-open end stopper)
3-13
E
2
to full-close posi-
d
is in
c
1
at the forward
2
to full-open posi-
3
4
.
Werbung
Kapitel
