Making A Dmo Group Call (Ms To Ms) - Motorola MTM800 Bedienungsanleitung

• The selected gateway address (e.g.:
1022), pre-programmed by your
Service Provider or previously
entered by yourself via the keypad.
Press Ok to use the current address, or enter a new
address via the keypad, and press Ok. The gateway
and repeater icons will flash upon selecting the
gateway.
• "None", indicating that no gateway
was selected for that talkgroup. Enter
an address via the keypad, and press
Ok. The Gateway and Repeater
icons will flash upon selecting the gateway.
When the MTM800 detects the appropriate
gateway and/or the Repeater, the Gateway
and/or Repeater icons will turn solid,
respectively.

Making a DMO Group Call (MS to MS)

1. Press
Mode
appears on your display.
2. Press
Menu
change range and talkgroup, see steps
3 and 4 of "Making a Group Call" on
page 34
3. If this is the desired talkgroup and range,
press the PTT button. Wait for the "Talk
permit" tone (if configured) and then
speak into the microphone. Release the
PTT button to listen.
To change talkgroup and range, see the Group Mode section,
page 30.
To change the Operating Mode quickly you can use one of the
programmable keys (if set up by your Service Provider).
until the Group Mode
6 2 2 (see also page 93). To
GW No: 1022
Avail. Rep.
Selected GW:
None
Back Ok
DMO Range1
DMO TG1
Optns
Range 10
Talkgroup 1
Status Optns
1 Trunk Mode
2 Direct Mode
Back Ok
DMO Range1
DMO TG1
Optns
45