Motorola MTM800 Bedienungsanleitung Seite 87

How to unlock the MTM800
The display shows Unit Blocked. When your MTM800 is
blocked, you cannot send or receive calls. You can only enter
a code or power off the MTM800.
To unblock the MTM800, enter the PUK (Personal
Unblocking Key). The PUK is an eight-digit master code to be
obtained from your Service Provider.
After entering the PUK successfully, you will be prompted to
replace the forgotten PIN code.
At the New Code? prompt, enter the new 4-digit code, and
repeat the code to confirm. If the code does not match, you
will be prompted to enter it again until the new code message
is accepted.
Change Code (
The standard factory lock code is "0000".
To change the PIN code:
1. Scroll to 3 Change Code and press Ok.
2. At the Old Code? prompt, enter the 4-digit code.
• If the old code does not match at verification, the display
shows the Incorrect Code Entered message and
returns to the Security sub-menu.
• If the entered code matches the old code, the display
prompts you to enter a new 4-digit code and to repeat it
for confirmation. If the confirmation code does not
match the new code, the display prompts you to re-
enter the new code.
3. When the new code is accepted, the display returns to the
Security sub-menu.
Air Encryption On/Off (
To enter the sub-menu, press
4 AirEncrypt.
3 3)
Menu
3 4)
Menu
- 3 Security -
Menu
81