Vox Control; Receiving Calls; Busy User Pre-Emption (Bup) - Motorola MTM800 Bedienungsanleitung

keypad. Pressing
number typed to the next mode.

VOX Control

VOX (Voice Operating Transmission) allows the user to transmit voice in a hands-
free condition. It detects audio automatically when full duplex private call and
telephone call use the fist microphone.
This feature is only available if set up by your Service Provider. If it
is disabled, transmittion can start upon pressing PTT.

Receiving Calls

The MTM800 will automatically switch to the mode of the
incoming call. After the incoming call ends, the display
returns automatically to the mode it was in before the
incoming call arrived.
In Private, Phone and PABX modes on receiving not Emergency
TMO or DMO group call the MTM800 stays in the current mode.
You can hear the call and the display remains unchanged.
Your MTM800 will alert you of an incoming call depending on
the setting you selected in Tones menu option (see page 89).
During message editing, you will be alerted of an incoming
Group/Emergency Group/Broadcast Group Call if configured
by your Service Provider.

Busy User Pre-emption (BUP)

This feature is only available if set up by your Service Provider.
A console operator, or dispatcher in the system might wish to
call you while you are in an on-going call (Private, Phone,
PABX). The console operator will activate the BUP feature to
interrupt and pre-empt your call.
BUP Invocation also pre-empts a call in process of being set up.
The call in setup must be a private, phone or PABX call.
while dialling a number will carry the
Mode
21