Transmit Inhibit - Motorola MTM800 Bedienungsanleitung

Receiving a Group Call with Scan On
With Scan On, you can receive a group call from the scan list
you set up, in addition to receiving a group call from the
selected talkgroup or from the associated ATG.
Receiving the scan call functions as
receiving an associated ATG or selected
call in scan off (see previous page), except
for the following:
• The display is different when receiving the call in idle
mode, as shown here.
• The MTM800 sounds a tone as explained in the note
below.
When receiving a High Priority Group Call, your MTM800 will
sound a "High Priority Group Call" tone (if configured by your
Service Provider).
When receiving a Group Call from your scan list, which is not
from a high priority group, your MTM800 will sound "New Group
Call" tone (if configured by your Service Provider).
Receiving an Emergency Group Call
For detailed information, see page 22.
Receiving a Broadcast Call
For detailed information, see page 23.

Transmit Inhibit

The Transmit Inhibit (TXI) Mode can be activated by the user
before he enters RF sensitive areas, e.g. in hospitals or in
potentially explosive areas, where safety can be jeopardized
due to terminal transmission radiation.
Radiation of the MTM800 is only suppressed if the TXI Mode is
activated or the terminal is separated from it's power supply.
Transmit Inhibit can only be activated in Group Mode. In
Transmit Inhibit Mode the terminal will not transmit under any
circumstances, except for the Emergency Group Call, which
can be initiated even if the MTM800 is in TXI Mode.
ID: 7712
TG 4
End
37