Selecting A Range; Activating/Deactivating Scanning; Making A Group Call - Motorola MTM800 Bedienungsanleitung

During the selection you cannot see calling party information.
When an Emergency Call is received, then selecting is aborted,
the MTM800 switches to the group mode and Emgcy In Use
display appears.
Selecting a group during a call
If you start selecting a group during a call, Group In Use or
Emgcy In Use display disappears.

Selecting a Range

To select a range:
1. In Group Mode, press Optns, followed by Range.
2. Use the navigation key to scroll through the ranges.
3. Press Ok to select the range (or press and hold PTT to start
the call in the new range).
The Service provider can configure range scrolling to:
• Stay in range — when the range end is reached during
talkgroup scrolling, further scrolling restarts the range
talkgroup list.
• Scroll to next range — when the range end is reached during
talkgroup scrolling, further scrolling switches to the talkgroup
list in the next range.

Activating/deactivating Scanning

See "Setting Talkgroup Scanning" on page 94.

Making a Group Call

1. Press
this example, "Range 10" is the last selected range and
"Talkgroup 1" is the last selected talkgroup.
If you press Optns, you have the option to select 1 abc,
2 Range, or 3 Scanning (see "Receiving a Group Call with
Scan On" on page 37).
2. If this is the talkgroup you wish to call, press and hold the
PTT. Wait for the "Talk permit" tone (if configured) and then
34
until Group Mode appears on your display. In
Mode