Selecting Dmo Group Call Options - Motorola MTP850 S Ausführliche Bedienungsanleitung

TMO
When the radio connects to a gateway, it plays a tone, displays the Gateway available message and shows an
appropriate icon. When the radio looses connection with the gateway, it plays a tone, displays the Gateway not
available message, and the gateway icon is blinking.

Selecting DMO Group Call Options

When and where to use: Helps to communicate with other radio users on the same talkgroup through the Gateway or
Repeater.
Procedure:
1 From the home screen, press Optns.
2 Press Config.
3 Select one of the following:
• MS - MS — Your radio can communicate only with other radios within its range.
• Gateway — Your radio uses a gateway to communicate with the infrastructure.
• Automatic — Your radio uses the first available gateway for that talkgroup.
• Specific — Your radio uses only the Gateway with the specified Gateway address for that talkgroup. If
your radio displays Selected Gateway:None, press Edit to enter the current gateway address.
• Repeater — Uses the first available repeater for that talkgroup.
• GW + Rep — Uses the first available gateway or repeater for that talkgroup.
• Automatic — Uses the first available gateway for that talkgroup.
• Specific — Uses only the Gateway with the specified Gateway address for that talkgroup. If your radio
displays Selected Gateway:None, press Edit to enter the current Gateway address.
Note: When the Gateway and the Repeater cannot be communicated even though a talkgroup to use
them is configured, the radio attempts the direct MS-MS communication.
When your radio detects the appropriate Gateway and/or the Repeater, the Gateway and/or Repeater icons turns solid,
respectively.
TMO
DMO
Modes | 49
| | Send Feedback