Led Status Indicators; Powering On/Off - Motorola MTM800 Bedienungsanleitung

LED Status Indicators

The LED indicators shows the in-service status of your
MTM800.
Indicator
GREEN: Solid
GREEN: Blinking
RED: Solid
RED: Blinking
AMBER: Solid
AMBER: Blinking
No indication

Powering On/Off

To power on:
• Press the On/Off pushbutton.
• If the MTM800 is configured with ignition sense, the radio
will automatically turn on whenever the vehicle ignition is
turned on.
• If an Emergency Foot Switch is connected to the
accessory connector and "Emergency with wake up" is
enabled by your Service Provider, the MTM800
automatically turns on in Emergency Mode whenever the
Emergency Switch is pressed (see "Emergency Mode" on
page 61).
A set of icons and squares will appear on your display. (See
"Icons" on page 8.) Then your MTM800 performs a self-
check and system registration routine. The display shows
additional information while the MTM800 is registering on the
system.
After successful registration, the MTM800 will be in service.
To power off:
• Press the On/Off pushbutton again.
Status
In use
In service
Out of service
Connecting to a network /
Entering DMO
Transmit Inhibit (TXI) in service /
Channel busy in DMO
Incoming call
Switched off
11