What To Do If - Motorola MTM800 Bedienungsanleitung

What to do if...

Your MTM800 flashes the following messages:
Messages
..... Mode List Empty
...-Rcvd
Attachment Failed
Authenticate Failure
Call Cancelled
Call Ended
Call Preempted
Emgcy Mic Ended
Emgcy Mic On
Empty Entry
Faulty Unit Error...
Group already exists
Group Mode
No Group
Invalid ID No Entry
Limited Service
List not Attached
List Partially Attached The scan list is active, but not all talkgroups are attached to
Message Description
There are no programmed entries in the scrolling list. Type
the entry.
Call received but not answered, or rejected.
The terminal could not perform talkgroup attachment. Try
another talkgroup.
The terminal could not register on an Authenticated system
(for example, the Authentication key is incorrect, or
Authentication is disabled in the terminal).
Faulty channel. Please try later.
Faulty channel. Please try later.
Called terminal ended the call.
Channel being used for priority.
The Hot Microphone timer has automatically expired, or the
user has pressed the PTT button to cancel the Hot
Microphone feature.
The Hot Microphone feature is active, and the terminal is
automatically transmitting hands free emergency audio.
The speed number you dialled does not exist, or the
number exists but the group is non-selectable.
Self-test failed. An operational fault has been detected with
your terminal. Record the error number. Turn your terminal
off and contact service.
The group you are attempting to add already exists in the
My Groups range.
Check group selected, and not "No Group" selected. If
correct group selected, attachment failed. Terminal
detached from current talkgroup. Please wait until the
terminal attaches again to the current talkgroup.
The entered number is not valid.
Emergency Calls, Emergency Alarms and mobility
operations (e.g.: group attachment) are allowed. All other
incoming and outgoing call and data services are blocked.
All talkgroups in the scan list are not attached.
it.
113