Private Call In Dmo - Motorola MTM800 Bedienungsanleitung

Private Call in DMO

If configured by your Service Provider it is possible to make
and receive a Private Call in DMO. You can make or receive
a DMO Private Call only when your MTM800 is in DMO.
Private Calls via DMO Repeater and/or DMO Gateway are not
supported.
The calling and called party shall be on the same talkgroup.
Making a DMO Private Call
1. To enter the Private Mode press
until Private Mode appears on the
display.
2. Enter a number like described in
"Entering the Private Number" on page 52.
3. Press and hold PTT. Wait for the talk permit tone (if
configured) before talking, and release the PTT when
listening.
4. The call ends after a pre-programmed time, or if you
press
There is no presence check for Private Calls in DMO. This
means you don't know whether the called party is available
when you starts the call.
Receiving a DMO Private Call
When a DMO Private Call is received, the
call is started immediately without need to
accept it by the called party.
1. Press PTT to talk back and start talking.
2. The call ends after a pre-programmed time, or if you
press
If the called party presses
suspended for a specified time and in case the calling party is
still transmitting the call is joined again.
.
.
Mode
Private Mode
2234
Status
Prvt in Use
David
the DMO private call is
abc
More
55