Wheel Balancing - Bosch WBE 4510 Originalbetriebsanleitung

9.

Wheel balancing

WARNING – Incorrectly balanced wheels
Risk of injury due to change in handling cha-
racteristics of vehicle.
€
WBE 4220 must be positioned on a flat
surface and must be firmly bolted to the
floor.
€
Specified flange must be mounted on cle-
an and grease-free shaft.
€
Use the specified accessories (cone, spa-
cer rings).
€
Rim must contact flange accurately, remo-
ve any dirt.
€
Perform a check measurement after ap-
plying balancing weights.
1. Switch on the WBE 4510 at the on/off switch.
« "The "Start page" is opened.
2. Open the "Rim data" menu, select the balancing pro-
gram with <u> and determine the rim data.
Robert Bosch GmbH
Wheel balancing | WBE 4510 | 49
9.1 Selection of vehicle type and balan-
cing program
i
Static balancing is recommended for wheels with
a width of less than 3.5'': In this case only the rim
diameter value is entered. The values for distance
and width of the rim can be set arbitrarily in inches
or mm.
1. Check the currently selected type of vehicle (pas-
senger car or motorcycle) in the status bar, alter if
necessary and confirm with <OK>.
2. Check the currently selected balancing program in the
status bar, alter if necessary and confirm with <OK>.
Standard program for clip-on weights
Alu1: Standard program for adhesive weights*
Alu2: Concealed adhesive weights
Alu3: Clip-on weights on inside /
concealed adhesive weights on outside
Alu4: Clip-on weights on inside /
adhesive weights on outside*
Alu5: Adhesive weights on inside /
clip-on weights on outside
Pax1: Pax rim with adhesive weights
Pax2: Pax rim for concealed adhesive weights
Static balancing on plane 1
Static balancing on plane 2
Static balancing on plane 3
* The weight must be raised slightly if the adhesive weight cannot
be attached in the vicinity of the outer edge of the rim (rim flan-
ge) on account of the design of the rim.
en
|
1 695 655 163 2010-07-17