User Information; Important Notes; Safety Instructions; Electromagnetic Compatibility (Emc) - Bosch WBE 4510 Originalbetriebsanleitung

2.

User information

2.1

Important notes

Important information on copyright, liability and warran-
ty provisions, as well as on equipment users and com-
pany obligations, can be found in the separate manual
"Important notes on and safety instructions for Bosch
Tire Service Equipment". These instructions must be
carefully studied prior to start-up, connection and opera-
tion of the WBE 4510 and must always be heeded.
2.2

Safety instructions

All the pertinent safety instructions can be found in the
separate manual "Important notes on and safety instruc-
tions for Bosch Tire Service Equipment". These instruc-
tions must be carefully studied prior to start-up, connec-
tion and operation of the WBE 4510 and must always be
heeded.
2.3

Electromagnetic compatibility (EMC)

The WBE 4510 satisfies the requirements of the EMC
directive 2004/108/EG.
i
The WBE 4510 is a class/category A product as
defined by EN 61 326. The WBE 4510 may cause
high-frequency household interference (radio inter-
ference) so that interference suppression may be
necessary. In such cases the user may be required to
take the appropriate action.
Robert Bosch GmbH
User information | WBE 4510 | 37
3.

Product description

3.1

Intended use

The WBE 4510 is a wheel balancing machine with
pneumatic quick-action attachment for the balancing
of passenger vehicle and motorcycle wheels with a rim
diameter of 10" – 26" and a rim width of 1" – 20". The
WBE 4510 is to be used exclusively for this purpose and
solely for the range of applications specifi ed in these
instructions. Any other purpose is not consistent with
the intended use and is therefore not permissible.
i
The manufacturer cannot accept any liability for pos-
sible damage arising from improper use.
3.2

Requirements

The WBE 4510 must be installed on a flat surface
made of concrete or similar and anchored in position.
A compressed air connection is also required.
i
An uneven or vibrating surface can lead to inaccurate
unbalance measurements.
3.3

Scope of delivery

Designation
WBE 4510
Quick-action clamping nut
Centering flange
Centering cones (3x) and adapters
Manual vernier caliper
Weight pliers
Measuring compasses
Calibrating weight
Wheel lift
3.4

Special accessories

Designation
Set of quick-action clamping cones M10x1.25 1 695 612 100
Third centering cone dia. 89 to 132 mm
Fourth centering cone dia. 120 to 174 mm
Spacer ring for rims (large rim offset)
Three-arm flange for light commercial
vehicles
Clamping kit for swinging arms (dia. 19 mm) 1 695 654 060
Infinitely variable universal flange for cars
(3-4-5 hole)
Motorcycle flange
Shaft kit, dia. 10 mm
Calibration weight (calibrated)
Printer with mount
en
Order number
Refer to rating
plate
1 695 616 200
1 695 602 400
–
1 695 629 400
1 695 606 500
1 695 602 700
1 695 654 377
1 695 900 004
Order number
1 695 653 449
1 695 606 300
1 695 606 200
1 695 653 420
1 695 654 043
1 695 654 039
1 695 653 430
1 695 654 376
1 695 654 956
|
1 695 655 163 2010-07-17