Heart Rate Value In A Sitting Position; Heart Rate Reserve; Heart Rate Variability - Polar CS600X Gebrauchsanleitung

ENGLISH
If you have done some hard training in recent weeks and know that you can safely reach maximum heart
rate, you can safely take a test to determine your HR yourself. Having a training buddy during the test
max
is recommended. If you are uncertain, consult your physician before undertaking the test.
Here is an example of a simple test.
Step 1: Warm up for 20 minutes on a flat surface, building up to your usual training pace.
Step 2: Choose a hill that will take more than 2 minutes to climb. Cycle up the hill once, building to as
hard a pace as you can hold for 20 minutes. Return to the base of the hill.
Step 3: Cycle up the hill again, building towards a pace you could just about hold for 10 minutes. Note
your highest heart rate. Your maximum is approximately 10 beats higher than the noted value.
Step 4: Cycle back down the hill, allowing your heart rate to drop 30-40 beats per minute.
Step 5: Cycle up the hill once again at a pace that you can only hold for 1 minute. Try to cycle halfway up
the hills. Note your highest heart rate. This brings you close to your maximum heart rate. Use this value as
your maximum heart rate to set training zones.
Step 6: Make sure you get a good cool-down, a minimum of 15 minutes.

Heart Rate Value in a Sitting Position

HR is your average heart rate when completely still (i.e. while sitting). To easily determine HR , wear
sit sit
your heart rate sensor, sit down, and do not engage in any physical activity. For a more precise
measurement, repeat the procedure several times and calculate your average.

Heart Rate Reserve

Heart rate reserve (HRR) is the difference between maximum heart rate (HR ), and resting heart rate
max
(HR )*. HRR is used to calculate exercise heart rates. It is the range within which heart rate varies
rest
depending on exertion level. HRR equals oxygen uptake reserve (VO R).
2
Exercise heart rate can be determined by using the Karvonen formula**. Add the given percentage of heart
rate reserve to resting heart rate.
Exercise HR = % of target intensity (HR – HR ) + HR
max rest rest
Example:
Target intensity 70 % HRR for a person with HR 201 bpm and HR 50 bpm
max rest
Exercise HR= 70% (201-50) + 50
Exercise HR=156 bpm
For a precise exercise heart rate, you need your exact HR and HR . When using estimated HR ,
max rest max
exercise heart rate values are always estimates.
*In Polar CS600X cycling computer, the heart rate value during a resting state is measured in a sitting
position (HR ). This is for practical reasons since HR is used in energy expenditure calculation because
sit sit
of accuracy. HR matches the low intensity to which different exercise intensities can be compared.
sit
**Karvonen M, Kentala K, Mustala O. The effects of training on heart rate: a longitudinal study. Ann Med
Exp Biol Fenn 1957; 35: 307-315.

Heart Rate Variability

Heart rate varies with every heartbeat. Heart rate variability (HRV) is the variation of beat-to-beat intervals,
also known as R-R intervals.
Backround Information 59