Using A New Accessory; Teaching A New Speed Sensor; Teaching A New Cadence Sensor; Teaching A New Power Output Sensor - Polar CS600X Gebrauchsanleitung

11. USING A NEW ACCESSORY

Using a New Accessory
A new sensor purchased as a separate accessory has to be introduced to the cycling computer. This is
called teaching and takes only a few seconds. Teaching ensures that your cycling computer receives
signals from your sensor only, and enables disturbance-free exercise in a group. If you have purchased the
sensor and the cycling computer as a set, the sensor has already been "taught" to work together with the
cycling computer. You just need to activate the sensor in your cycling computer.
You can teach one Speed, Cadence and Power sensor for each bike setting.

Teaching a New Speed Sensor

Select Settings > Bike > Bike1/2/3 > Speed > On/Off
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Speed sensors. Then select
confirm teaching. Start test drive
flashing red light indicates that the sensor is activated.
is over. The cycling computer is now ready to receive speed and distance data.
• Select No to cancel teaching and the already earlier taught speed sensor is taken into use.
Once the speed sensor is taught to recognize the cycling computer, it will do so even if the sensor has been turned
off. When the speed sensor is turned back on
monitor goes into teaching mode.
For a video tutorial, go to http://www.polar.com/en/polar_community/videos.

Teaching a New Cadence Sensor*

Select Settings > Bike > Bike1/2/3 > Cadence > On/Off
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Cadence sensors. Then select
to confirm teaching. Start test drive
flashing red light indicates that the sensor is activated.
is over. The cycling computer is now ready to receive cadence data.
• Select No to cancel teaching. The cycling computer will not be able to measure cadence data.
Once the cadence sensor is taught to recognize the cycling computer, it will do so even if the sensor has been
turned off. When the cadence sensor is turned back on next time,
and the monitor will go into
monitor goes into teaching mode.
For a video tutorial, go to http://www.polar.com/en/polar_community/videos.

Teaching a New Power Output Sensor*

Select Bike > Bike1/2/3 > Power > On/Off
• To teach a new sensor, make sure you are not near (40 m/131 ft) other Power Output sensors. Then select
Yes to confirm teaching.
sensor. A flashing red light indicates that the sensor is activated.
teaching process is over. The cycling computer is now ready to receive power data.
• Select No to cancel teaching. The cycling computer will not be able to measure power data.
Once the power sensor is taught to recognize the cycling computer, it will do so even if the sensor has been turned
off. When the power sensor is turned back on, the
go into mode. The power sensor last taught will be taken into use. If
On/Off
goes into teaching mode.
is displayed. Rotate the wheel a few times to activate the sensor. A
Teach new sensor?
is displayed. Rotate the wheel a few times to activate the sensor. A
mode. Select
On/Off ON
. Teach new sensor?
Start test drive is displayed. Rotate the wheel a few times to activate the
Teach new sensor?
. Teach new sensor? is displayed
Completed! ! is displayed once the teaching process
is displayed. Select
. Teach new sensor?
Completed! ! is displayed once the teaching process
Teach new sensor?
to activate the cadence sensor. If
is displayed.
Completed!
is displayed. Select
is selected, the cycling computer
Yes
Using a New Accessory
ENGLISH
Yes
. If is selected, the
NO YES
is displayed
is displayed. Select
NO
is selected, the
YES
! is displayed once the
. The monitor will
NO
to
Yes
55