Using A New Heart Rate Sensor; Teaching A New Heart Rate Sensor - Polar CS600X Gebrauchsanleitung

ENGLISH

10. USING A NEW HEART RATE SENSOR

Using a New Heart Rate Sensor
Your CS600X cycling computer has been taught to work together with the Polar H3 heart rate sensor. In
other words, your cycling computer receives signals from your heart rate sensor only, and enables
disturbance-free exercise in a group.
If you purchase a new heart rate sensor as a separate accessory, it has to be introduced to the cycling
computer. This is called teaching and takes only a few seconds.
To prevent interference during a cycling event, make sure you perform the teaching process prior to the
event.

Teaching a New Heart Rate Sensor

Wear the heart rate sensor and make sure that you are not near (40 m/131 ft) other heart rate sensors. In
time mode, press OK. The cycling computer starts searching for the heart rate sensor signal.
Once the new heart rate sensor is identified,
• Select Yes to confirm teaching.
recording by pressing OK.
• Select No to cancel teaching.
Your cycling computer refers to the heart rate sensor as
54 Using a New Heart Rate Sensor
New WearLink found, Teach new WearLink?
Completed! is displayed once the teaching process is over. Start exercise
WearLink
is displayed.
.