Connector Assignments Of Slot Vii (5-Terminal) Input For Batch Pulse And Metering Lock; Installing The Batch Pulse - ECOLAB Elados EMP III E60 Betriebsanleitung

8.2.2 Connector assignments of Slot VII (5-terminal)
input for batch pulse and metering lock
Fig. 8.6 Connector assignments of slot VII (5-terminal), input for batch pulse and metering lock
 Remove the protective cap
 Mount the connector plug according to the connector assignment.
WARNING

8.2.2.1 Installing the batch pulse

NOTE
= Input batch metering with potential-free contact with selection input „pulse" at
2 + 4
configuration / batch (see chapter 10.3.14).
PIN Assignment
2 Relay input
GND (┴)
4
= Input batch metering with electronic switch (NPN) with selection input „pulse" at
1 +2 + 4
configuration / batch (see chapter 10.3.14)
PIN Assignment
1 5 V, DC
2 Relay input
GND (┴)
4
or
= Input batch metering with potential-free contact with selection input „metering lock" at
3 + 4
configuration / batch (see chapter 10.3.14).
PIN Assignment
3 Relay input
GND (┴)
4
= Input batch metering with electronic switch (NPN) with selection input „metering lock" at
1 +3 + 4
configuration / batch (see chapter 10.3.14).
PIN Assignment
1 5 V, DC
3 Relay input
GND (┴)
4
417101441_EMP_III_E60.docx
Conductor coloring
Pin
(cable connection)
1 brown
2 white
3 blue
4 black
5 grey
Only use a connector plug from our product range!
The batch function must be activated in menu first. The selection must also be made of
(input "pulse") or
whether the pins 2+4
batch metering start pulse (see chapter
Assignment
Output 5 V, DC (load with max. 50 mA)
Input batch metering
Input metering lock
GND (┴)
Free for future use
(input "metering lock") should be used for the
3+4
"Configuration / batch")
10.3.14
Fig. 8.7 Installing the batch impulse
- 89 - Rev. 12-08.18