Installing The Control Via The Metering Lock; Installing The Batch Function - ECOLAB Elados EMP III E60 Betriebsanleitung

7.2.4.3 Installing the control via the metering lock

NOTE

7.2.4.4 Installing the batch function

NOTE
= Input batch function with potential-free contact with selection input „pulse" at
2 + 4
configuration / batch (see chapter 10.3.14).
PIN Assignment
2 Relay input
GND (┴)
4
= Input batch function with electronic switch (NPN) with selection input „pulse" at
1 +2 + 4
configuration / batch (see chapter 10.3.14).
PIN Assignment
1 5 V, DC
2 Relay input
GND (┴)
4
or
= Input batch function with potential-free contact with selection input „metering lock" at
3 + 4
configuration / batch (see chapter 10.3.14).
PIN Assignment
3 Relay input
GND (┴)
4
= Input batch function with electronic switch (NPN) with selection input „metering lock" at
1 +3 + 4
configuration / batch (see chapter 10.3.14).
PIN Assignment
1 5 V, DC
3 Relay input
GND (┴)
4
417101441_EMP_III_E60.docx
The metering lock function must be activated in menu first. (see chapter:
"Configuration metering lock"). The metering lock is available in all operation modes.
The batch function must be activated in menu first. The selection must also be made of
(input "pulse") or
whether the pins 2+4
batch metering start pulse (see chapter 10.3.14.)
3 + 4 = Input metering lock
with potential-free contact
PIN Assignment
3 Relay input
GND (┴)
4
1 +3 + 4 = Input metering lock
with electronic switch (NPN)
PIN Assignment
1 5 V, DC
3 Relay input
GND (┴)
4
Fig. 7.19 Installing the control via the metering lock
(input "metering lock") should be used for the
3+4
Fig. 7.20 Installing the batch function
- 83 -
10.3.7
Rev. 12-08.18