Check The Gear Oil Level - Jungheinrich EFG 113 Betriebsanleitung

6.4.2 Replacing the hydraulic oil filter
Replace oil filter
Requirements
– Park the truck securely, (see "Parking the
truck securely" on page 70)
Procedure
• Unscrew the hydraulic oil filter cap (131). The
filter element is located on the cap.
• Replace the filter insert; if the O ring is damaged it will also need to be replaced.
Apply a thin layer of oil to the O ring on assembly.
• Refit the cap with the new filter element in place.
6.5

Check the gear oil level

CAUTION!
Consumables and used parts are an environmental hazard
Used parts, oils and fuels must be disposed of in accordance with the relevant
environmental protection regulations. To change the oil contact the manufacturer's
customer service department, who have been specially trained for this task.
Note the safety regulations when handling these materials.
Check the gear oil level
Requirements
– Park the truck securely, (see "Parking the truck securely" on page 70)
Tools and Material Required
– Oil sump
Procedure
• Place the oil sump underneath the transmission
• Unscrew the oil dipstick (134).
• Check gear oil level, top up if necessary through the filler hole (133).
Z
The oil level should reach the bottom mark of the oil check hole (134).
The transmission oil level is now checked.
Draining the oil
Procedure
• Drain oil at operating temperature.
• Place the oil sump underneath the transmission
• Unscrew the oil drain plug (135) and drain the
transmission oil.
Z
To ensure swift and complete draining of the
transmission oil, unscrew the oil dipstick (134).
140
131
132,133
134
135