6.6
Lift cutout override
Z
A lift cutout device can be factory fitted when working in areas of restricted height.
This interrupts lifting.
To continue lifting:
Procedure
• Press the lift cutout override button ((see "Side
compartment control panel switch (o)" on
page 55)).
• Pull the control lever (107).
Lift cutout is deactivated until the button is
pressed again or the fork carriage is lowered
below the height limit setting.
6.7
Fire extinguisher
Procedure
• Open the fasteners (117)
• Pull the fire extinguish out of its bracket
Z
To operate, refer to the illustrations on
the fire extinguisher
102
107
117