Jungheinrich EFG 113 Betriebsanleitung Seite 60

Checks before daily operation
Procedure
• Visually inspect the entire truck (in particular wheels,
wheel bolts and load handler) for damage.
• Check the fork stop (88) and fork retainer (89).
• Visually inspect the hydraulic system in the visible
area for damage and leaks.
• Make sure the driver's seat is locked in position.
• Test the horn and reversing buzzer (o) where
applicable.
• Check that the load chart and warning labels are
legible.
• Test the controls and displays.
• Test the steering.
• Check the steer angle display (o), turn the steering wheel in both directions as far
as the stop and check that the wheel position is displayed on the control panel.
• Make sure the load chains are evenly tensioned.
• Test the seat belt. (The belt should block if extracted suddenly.)
• Test the seat switch. When the driver's seat is vacated it should not be possible to
activate the hydraulics.
• Test the restraint system (o).
• Test the Drive Control (o).
• Raise the fork carriage without load beyond the reference point on the mast. The
slow travel symbol lights up on the display.
• Slowly apply the accelerator pedal on a clear route with good visibility. The
maximum speed should be reduced to walking pace (3 km/h).
• Test the lift/lower, tilt and if applicable the attachment hydraulic control functions.
• Check the accelerator pedal can move freely while the parking brake is applied and
the truck is idling, by pressing it several times.
• Visually inspect the battery attachment and cable connections.
• Check the battery lock is present and working.
•
• On trucks with lateral battery removal, check
the left and right stops (90) in the battery
compartment for damage.
• Check the fluid level of the window washer
system, (see "Preparing
operation" on page 68).
the truck for
88
89
90
59