Preparing The Truck For Operation - Jungheinrich EFG 113 Betriebsanleitung

4.2

Preparing the truck for operation

Switching on the truck
Requirements
– For checks and operations to be performed before starting daily operation, (see
"Checks and operations to be performed before starting daily operation" on
page 58).
Procedure
• Unlock the Emergency Disconnect switch (62) to do this
• Press the rocker in (s) and pull it up until you feel the Emergency Disconnect
switch engaging.
• Insert the key in the key switch (58) and turn it clockwise as far as it will go to the
"I" position.
• Test the brake pedal and parking brake.
The truck is now ready for operation. The display (101) shows the remaining battery
capacity.
Z
When you have pulled the EMERGENCY DISCONNECT and turned the key switch
to the right, the truck carries out a self test for approx. 3-4 seconds (tests the
controllers and motors). During this time the truck cannot move or lift. If the
accelerator or a lift mechanism lever is applied during this time, an information
message will be displayed.
68
62 101 58