Troubleshooting - Jungheinrich EFG 113 Betriebsanleitung

7

Troubleshooting

7.1 Troubleshooting
This chapter enables the user to identify and rectify basic faults and the effects of
incorrect operation. When trying to locate a fault, proceed in the order shown in the
table.
Z
If, after carrying out the following remedial action, the truck cannot be restored to
operation or if a fault in the electronics system is displayed with a corresponding
error code, contact the manufacturer's service department.
Additional troubleshooting must only be performed by the manufacturer's specialist
service engineers. The manufacturer's customer service department is specially
trained to carry out these operations.
In order for customer services to react quickly and specifically to the fault, the
following information is essential:
- Truck serial number
- Error number on the display unit (if applicable)
- Error description
- Current location of truck
Info messages
Display
Info 03
Info 35
Info 36
Info 40
Info 90
Info 96
106
Meaning
Traction or lift controller temperature above 83°C
Accelerator pedal zero position
– Message can be set via parameters: either the zero position is
only checked after power up or after every change of seat
switch status from open to closed.
Hydraulics zero position
– Message can be set via parameters: message displayed or
not.
Overtemperature
– Traction or lift motor above 145?.
Travel against parking brake
– Accelerator pressed while parking brake applied.
– Seat switch not occupied and parking brake not applied.
Hydraulics zero position on truck power up
– A hydraulic function applied during power up.
– The hydraulic function applied will not be performed.