Jungheinrich EFG 113 Betriebsanleitung Seite 82

4.12.1 Operating the lift mechanism with the SOLO PILOT
Lifting and lowering
Requirements
– To prepare the truck for operation, (see
"Preparing the truck for operation" on page 68)
Procedure
• Pull the Solo-Pilot lever (107) in direction H to
raise the load.
• Push the Solo-Pilot lever (107)in direction S to
lower the load.
The load is now raised / lowered.
Z
When the limit position for the operation has been reached (there will be a noise
from the pressure relief valve) release the lever. The lever will revert automatically
to neutral.
Tilting the mast forward / backward
Requirements
– To prepare the truck for operation, (see
"Preparing the truck for operation" on page 68)
Procedure
• Pull the Solo-Pilot lever (108) in direction R to
tilt the mast back.
• Push the Solo-Pilot lever (108) in direction V to
tilt the mast forward.
The mast is now tilted back / forward.
Z
When the limit position for the operation has been reached (there will be a noise
from the pressure relief valve) release the lever. The lever will revert automatically
to neutral.
S
107
H
V
108
R
81