Jungheinrich EFG 113 Betriebsanleitung Seite 126

Overhead guard cover
Chassis and Superstructure
Check overhead guard cover is present, check for damage and
1
make sure it is secure.
Fire extinguisher
Agreed performance levels
1 Check fire extinguisher is present, secure and check the test interval.
Belt lock control
Chassis and Superstructure
1 Test the belt lock control and check for damage.
Clamping device
Hydraulic operations
1 Attachment: clean and lubricate.
2 Check hydraulic ports and tighten if necessary.
Check the axial play of the front and rear rollers and adjust if
3
necessary.
4 Check the sliding blocks are complete.
5 Check cylinder seals.
6 Test attachment, check settings and check for damage.
7 Test the hose reel and check for leaks and damage.
8 Check the cylinder piston rods and bushings.
Attachment: check bearing points, guides and stops for wear and
9
damage, grease and clean these components.
Check attachment is properly secured to the truck and the
10
supporting elements.
Crane hook
Hydraulic operations
Check attachment is properly secured to the truck and the
1
supporting elements.
Safety restraint system / SUN protector
Chassis and Superstructure
Make sure restraint system is complete, test operation and check for
1
damage.
2 Test the restraint system sensor system and check for damage.
3 Check the electrical connections are secure and not damaged.
W A B C
t
W A B C
t
W A B C
t
W A B C
t
t
t
t
t
t
t
t
t
t
W A B C
t
W A B C
t
t
t
125