If The Machine Is Not Used For A Longer Period Of Time / Disposing Of The Machine; If The Machine Is Not Used For A Longer Period Of Time; Disposal - probst POWER PLAN PP Bedienungsanleitung

Operating instructions
PP
6.6

If the machine is not used for a longer period of time / disposing of the machine

6.6.1

If the machine is not used for a longer period of time

If the machine will not be used for more than 2 months:

Park the machine on even ground and in a dry place inside a hall or, if parked outside, on even ground and fully
cover with a dark tarpaulin.
 Thoroughly lubricate all lubrication points. See "Lubrication".
 Replace the engine oil with anti-corrosion oil.
Leave the engine to run for a few minutes to allow the anti-corrosion oil to evenly distribute.
 Check the mixing ratio of the antifreeze and water in the coolant and adjust if necessary.
 Top up the fuel with 10 % of anti-corrosion oil.
Leave the engine to run for a few minutes to allow the internal components of the injection system to be wetted
with anti-corrosion oil.
 Coat the exposed piston rods of the levelling cylinders with anti-corrosion grease such as a Shell anti-corrosion
grease.
 Remove the battery, store it in a frost-proof place and regularly recharge. See "Maintaining the battery".
 Fill the fuel tank with diesel up to the brim. See section on "Checking the fuel level".
 Remove the v-belt and store.
 Spray the groves of the v-belt pulleys with anti-corrosion oil.

Cover the exhaust pipe opening with rigid foil and seal with adhesive tape.
 In areas with high humidity (tropical climates), top up the hydraulic fluid tank up to the brim.
Before taking the machine back into operation:
 Remove the foil and tape from the exhaust pipe.
 Charge and install the battery. See "Maintaining the battery".
 Remove the anti-corrosion oil from the v-belt pulleys.
 Fit the v-belt.
 Adjust the hydraulic fluid level.
 Remove the anti-corrosion oil from the piston rods of the levelling cylinders.
 Replace the anti-corrosion oil with engine oil.
If the machine has not been used for more than 12 months:
 Change the hydraulic fluid.
6.6.2

Disposal

Risk of environmental damage
Failure to professionally dispose of the machine at the end of its life cycle can lead
to environmental damage.

66 / 70
Maintenance and care
The machine must only be disposed of by a qualified disposal company.
V1
EN