Cleaning The Machine With A Pressure Washer; Cleaning The Outside Of The Engine - probst POWER PLAN PP Bedienungsanleitung

Operating instructions
PP
6.3.3

Cleaning the machine with a pressure washer

If the machine is heavily soiled, including with oil and fuel:
 Keep the pressure washer's nozzle at least 300 mm away from the machine.
 The pressure washer's jet pressure must not exceed 100 bar.
 The water jet temperature must be 80-90 °C.
 Only use neutral or alkaline detergents.
 Use a brush or a similar aid to remove solid dirt deposits.

After cleaning, lubricate the machine. See "Lubrication".
6.3.4

Cleaning the outside of the engine

 The cleaning methods listed below should be used depending on the level of soiling.
 Protect electronic components and seals from direct contact with water.
 Leave the engine running until it gets warm after cleaning to allow residual water to evaporate and prevent the
formation of rust.
55 / 70
Maintenance and care
V1
EN