Changing Light Bulbs - probst POWER PLAN PP Bedienungsanleitung

Operating instructions
PP
6.5.9

Changing light bulbs

Risk of personal injury and damage to property
Light bulbs and lamp holders become hot when the lights are switched on. They
can cause burns if touched and can ignite flammable objects.



Risk of damage to property
Failure to change light bulbs properly can lead to short circuits.




65 / 70
Maintenance and care
Keep at a minimum distance of 500 mm from flammable objects.
Turn off the lights in plenty of time before changing light bulbs.
Allow lamps to sufficiently cool before changing light bulbs.
Allow lamps to sufficiently cool before changing light bulbs.
Do not touch the glass bulbs of the lamps with bare hands. Even minor particles can burn
into the light bulbs and reduce their service life.
Only touch light bulbs with a clean, dry and lint-free cloth.
Observe the light bulb's type, volts and Watts.
Light bulbs H3, 55 W, 12 V DC
The procedure described below applies
both to changing the headlights' and
working headlights' light bulbs.
1. Open the housing cover (1) by
turning it.
2. Press together the clamp and
remove it.
3. Remove the cable (3) from the
connector (4).
4. Remove the light bulb holder with
the defective light bulb (5) and
remove the defective light bulb.
5. Fit the new light bulb in reverse
order.
V1
EN