3.14 Maintenance - probst POWER PLAN PP Bedienungsanleitung

Operating instructions
PP

3.14 Maintenance

Risk of personal injury and damage to property
Failure to perform maintenance work properly can lead to injury and
environmental damage.










Risk of personal injury and damage to property
If the machine's electrical system is not in perfect working order, there is a risk of
injury and damage.






Risk of personal injury and damage to property
Failure to perform the machine's first scheduled inspection can lead to injury and
damage.

Risk of personal injury and damage to property
There is a risk of fire and explosions when performing maintenance and inspection
work.





16 / 70
The machine must only be maintained by qualified personnel and as specified in the
operating instructions. See "Personnel requirements".
Only perform maintenance work on level and adequately load bearing ground.
Only open the engine hood when the engine has been switched off.
Adequately secure the components that need to be maintained to prevent them from
falling down.
Switch off the main switch to prevent the electrical system from becoming damaged and
the machine from being accidentally started.
Do not place any metal objects or tools onto the battery.
Only use original Probst spare parts and approved operating fluids. Failure to do so will
void the warranty.
In winter, only fuel the machine using winter diesel.
Reattach and/or reconnect all safety equipment, such as the EMERGENCY STOP button,
engine hood, etc. before restarting the machine.
Observe the relevant environmental protection, recycling and disposal regulations.
The electrical system must always be kept in proper working order.
Do not operate the machine if any of its fuses are missing.
Replace broken fuses immediately.
Always switch off the electrical system by switching off the main switch before
commencing any work on the electrical system and in particular before disconnecting
electrical lines.
If jump-starting the machine, the charging circuit must be 12 V.
Only use digital multimeters or voltmeters to test the electrical system. Do not use a test
lamp.
The first inspection must be performed after 50 operating hours.
Never refuel the machine when the engine is running.
Do not smoke.
Do not use open flames.
Keep a fire extinguisher within reach.
Store cleaning cloths that are soaked with flammable fluids in non-combustible, sealed
containers.
Safety
V1
EN