General Information; General; Correct Use; Incorrect Use - probst POWER PLAN PP Bedienungsanleitung

Screeding machine

Inhaltsverzeichnis

Operating instructions

General

4.1

Correct use

Screeding Machine POWER PLAN PP

The

could, for example, be aggregates and sand with grain sizes of 0-56 mm (#) or earth-moist concrete. Depending on

the sub-base requirements, the sub-base's height can be measured by ultrasound or laser.

Ultrasound is used if the installation site has several different inclines, such as an inward slope, or includes small

areas that have different heights. In this case, it is necessary to set up two lines of string that are exactly parallel to

one another for one line, along which the

height sensor. If there are kerbstones, rails or asphalt edges, there is no need to set up any lines of string.

The laser is used if the installation site has one or several slopes. In this case, it is necessary to establish the two

axes of the area and the incline. The laser sender must be set up and adjusted at the point where the two axes

intersect.

(#) Example for determining the installation height:

Factor 2.5 x grain size/gravel size = Installation height for the sub-base

2.5 x 25 mm grain size = 62.5 mm (6.25 cm) -> Sub-base height 6 25 cm

4.2

Incorrect use

It is prohibited to use the

"Correct use".

It is prohibited to make any unauthorised modifications to the machine and to use any, potentially self-built,

additional equipment.

It is prohibited to transport people, animals, packaged construction materials and similar with the

POWER PLAN PP.

It is prohibited to attach loads to the

The Screeding Machine POWER PLAN PP must not be used on public roads, and is designed only for use on

construction and private sites.

4.3

Warranty

The manufacturer does not accept warranty claims that arise from incorrect use, incorrect operation, insufficient

maintenance or the use of unapproved operating fluids.

Failure to use original Probst spare parts will void the warranty.

When ordering spare parts or making claims under the warranty and/or for all other enquiries, please always state

the machine type, machine number and year of manufacture. See "Type plate information".

19 / 70