probst POWER PLAN PP Bedienungsanleitung Seite 62

Operating instructions
PP
62 / 70
Maintenance and care
V1
1. Open the engine hood. See
"Opening the engine hood".
2. Remove the protective cap from the
positive terminal.
3. Connect the positive lead (1) to the
positive terminal on the second
battery.
4. Connect the positive lead (1) to the
positive terminal (2).
5. Connect the negative lead to the
negative terminal on the second
battery.
6. Earth the negative lead on the
machine, e.g. connect it to the
engine or frame.
7. Start the motor of the vehicle you
are using to jump-start the
machine.
8. Start the engine of the machine.
See "Starting the engine".
9. Once the motor has started,
disconnect the minus lead first
while the engine runs at idle speed.
Always start with the other vehicle's
battery when disconnecting the
leads.
10. Disconnect the positive lead (1)
from the positive terminal (2).
Always start with the other vehicle's
battery when disconnecting the
leads.
11. Attach the protective cap over the
positive terminal.
12. Close the engine hood.
EN