Inhaltsverzeichnis
Werbung
Operating instructions
PP
Charging the battery
Risk of personal injury and damage to property
Failure to properly charge empty or frozen batteries can lead to injury and
damage.
Jump-starting
If the battery is empty:
The machine can be jump-started with another vehicle with an on-board voltage of 12 V.
The machine can be started using a suitable charger.
Risk of personal injury
Failure to jump-start the machine properly can lead to injuries.
Risk of damage to property
Jump-starting the machine can cause damage to the electrical system.
61 / 70
Maintenance and care
Empty batteries can already start to freeze at temperatures of -10 °C.
Check frozen batteries for frost damage (damage to housing).
Allow frozen and undamaged batteries to defrost before charging.
Make sure to connect and disconnect the battery in the stated order.
The charging circuit must be 12 V.
If the machine is jump-started with the help of a charger, only use a charger with an
output stabilization control.
Always make sure that the connecting clamps are connected to the right terminals.
Only use adequately dimensioned jump-start leads (min. 95 mm²).
Do not jump-start the machine if the battery has been taken out of the machine or has
been disconnected.
Do not jump-start the machine if the battery is damaged.
1. Open the engine hood. See
"Opening the engine hood".
2. Remove the protective cap from the
positive terminal.
3. Connect the positive lead (1) to the
positive terminal (2).
4. Connect the negative lead (3) to
the negative terminal (4).
5. Set up the charger as specified in
the device manufacturer's operating
manual and switch it on.
6. Once the battery is fully charged,
switch off the charger.
7. Disconnect the negative lead (3)
from the negative terminal (4).
8. Disconnect the positive lead (1)
from the positive terminal (2).
9. Attach the protective cap over the
positive terminal.
10. Close the engine hood.
V1
EN
Werbung
Kapitel
Inhaltsverzeichnis
