Switching The Machine Off; Transport; General Information - probst POWER PLAN PP Bedienungsanleitung

Operating instructions
PP
5.5.11

Switching the machine off

5.6

Transport

5.6.1

General information

The following points in particular must be observed:
 Take note of the machine's loading dimensions. See "Dimensions".
 Take note of the machine's transport weight. See "Technical data".
 When transporting the machine on a lorry, take down the driver's cab roof on the lorry and secure. See "Taking
down the driver's cab roof".
46 / 70
Operating the machine
V1
1. Park the machine on solid and even
ground.
2. If parked on an incline, protect the
machine from moving.
3. Fully lower the smoothing board.
See "Raising/lowering the
smoothing board"
4. Switch off the engine.
5. Switch off the electrical system at
the main switch. See "Main switch".
6. Undo the screw connection (1) of
the MOBA control unit on the left
and right side of the machine.
7. Undo the quick fastener (2) of the
manual control unit on the left and
right side of the machine.
8. Remove the MOBA control unit,
manual control unit and laser
receiver and store in a save place.
9. If necessary, push in any linear
guide units and secure. See
separate operating tips in the
section "Adjusting the ultrasonic
height sensors".
10. If necessary, fully push in the chain
guide and secure. See separate
operating tips in the section "Chain
guide".
11. Clean the hopper.
EN